The term standing seam comes from the connections between the metal panels that are raised.
Standing seam metal roof hip detail.
Deck w iso details.
Colonial seam continuous standing seam metal roof panel with an integral seam.
Standing seam roofs are generally made from thicker grades of steel than corrugated steel roofs.
Rake to masonry wall detail.
Rake to metal wall detail.
Standing seam trim details a brief guide to the various trims used for standing seam metal roofing as well as how they are installed.
Rivet hip ridge flashing to top flange of zees at 18 inches on center both sides.
Install zee closures onto panels at both sides.
Pac 150 90 single lock.
The most common flashing for standing seam roofing is the ridge cap which is used at the peak of a roof where two opposing roof slopes join and attaches to the roof with z flashing.
Other flashings include gable trim which runs up the sloped ends of the roof and drip edge or eave trim.
Pac 150 180 double lock.
Butyl sealant tape or tube sealant should be used under all z channel.
Use hip ridge flashing to locate correct position of zee closures.
This method allows standing seams to be concealed by a ridge cap which affords both a clean appearance and weather tight seal.
While many corrugated steel roofs are made using the thinner 29 gauge steel a minimum of 26 gauge g 90 galvanized steel or more commonly galvalume steel better is used for manufacturing of standing seam metal panels.
Fasten with appropriate substrate fastener at minimum 4 fasteners per zee or 3 inches on center.
This guide is does not cover some aspects of installation.
Clipless one piece positive locking standing seam panel that provides a timeless roof appearance.
The seams run vertically and are created by folding and crimping the edges between the panels.
For longer slopes and lower roof pitches contact fabral for other suitable profiles.
These roofs require minimal maintenance and provide both extreme resistance to high winds and a high fire rating.
Roof pitch the metal roofing panels shown in this manual require a mini mum slope of 2 per foot to ensure proper drainage.
Install additional sections of hip ridge flashings with minimum 4 inch end laps and tube sealant at laps.
Apply a row of tube sealant along back face of zee closure adjacent to panel legs.
A 24 and 22 gauge steel can also be used.