It is important that the electrode be kept moving without stopping too.
Spark test procedure for rubber lining.
Rubber is to be supported so as not to be stretched during application.
The proper way to spark test is to calibrate the voltage to a known leak.
Vessel is vulcanised on the same day once this process is completed the vessel then undergoes a final inspection as seen in photo this once gain includes a full spark test.
Rubber lining application manual revision date.
The spark tester is to be calibrated using a test calibration block the same power source probe and cable length to assure the setting on the probe is unchanged.
Spark testing of rubber lined vessel the rubber lining of the vessel is completed on the 12th december 2014 a full spark test is carried out pre vulcanisation.
Spark testing is not an absolute test meaning that it is not 100 fail safe.
Spark testing is a standard procedure used for inspecting glass lined equipment.
To discuss your spark testing hardness.
September 1 2009 section 13.
How to identify metals with basic shop tools and the spark test tig time duration.
Technique visual inspection equipment maintenance and rubber lining application experience are all essential in reducing errors misinterpreting results and completing the spark test with meaningful result.
The lining shall be free of blisters porosity and tears.
Spark testing is not an absolute test meaning that it is not 100 fail safe.
Inspection spark testing procedures in spark testing it is recommended that the equipment be calibrated for testing.
5 way distributor rubber lining spark test.
Technique visual inspection equipment maintenance and rubber lining application experience are all essential in reducing errors misinterpreting results and completing the spark test with meaningful results.
Spark testing rubber lining spark testing can cause more damage and leaks than it may discover if done improperly.
13 2 3.
During testing the entire glass lined surface is examined and any chips cracks pinholes and other defects are documented and marked for repair.
Test procedure keep electrode in light contact with rubber and move back and forth at the rate of approximately 1 ft sec.
This procedure is detailed below.
Spark testing method is a test method of checking the quality of the rubber lining or rubber coating on the internal as well as external surface of the react.
Test equipment 1 1 high frequency ac spark testers are.
One of the biggest mistakes is done when specifying the voltage.