Once you have determined that your concrete floor is not damp you can successfully install self adhesive vinyl tile after removing carpet.
Self stick vinyl tile on concrete.
Repair any gaps cracks or holes in the existing floor by cutting.
Peel and stick tiles will stick to painted concrete or wood if the surface is clean but they will not adhere to any type of wax.
Usually vinyl floor tiles have a peel and stick style installation.
Like others i would be more inclined to use a ceramic tile or glue down vinyl but you already have the self stick so.
You can keep installing the tiles working from the center towards the walls.
Once you figure out your layout you peel the backing of one tile at a time and press it onto the floor.
Its 2057 product which is available for purchase online can be applied to a range of subfloors including vinyl composition vinyl asphalt tile plywood and concrete.
Paper backing covers the tile adhesive until you re ready to install.
Sometimes self stick vinyl tiles won t stick only after the fact.
You can install them removing the back paper to expose the sticky part of the tiles.
I have used armstrong peel and stick tile on several jobs and some knockoff brands on a few.
Make sure that the concrete surface is clean and will adhere to the tile.
Peel and stick tile is a cost effective way to save time on installation.
To fix a tile that pops up later reactivate the adhesive by heating it up with an iron.
Peel and stick tiles are usually made from vinyl and have a self adhesive backing that sticks to most smooth flat surfaces.
The thin formula dries clear and can be washed away with warm soapy water before its 24 hour drying time.
Take the vinyl tiles and place them in the center of the room where the lines bisect.
The tiles will adhere more readily to plywood than to concrete.
Cover the concrete with 1 4 inch plywood and secure it with 1 1 4 inch underlayment nails.
Then weigh the tile down with a nice stack of heavy books or bricks.
Place a second uncut tile over top of the open space overlapping the tile you just placed below make sure it is flush with the wall then use the bottom to mark the tile beneath.
If the concrete holds moisture however the tiles may.
Anything that s stackable and heavy that you have handy will work.
If you get the concrete really clean and you use a good self stick vinyl tile you should be ok without any addtional adhesive.